DMP Electronics XR500 SERIES Spécifications télécharger pdf (Page 170)

Zone 2 Options

Activate Zone 2 Bypass: Select to enable the Bypass option. Disabling allows standard zone

operation on Zone 2. Default setting is disabled.

If the door being released by the 734/734N/734N-WiFi module is protected (contact installed), you can

provide a programmable Bypass entry/exit timer by connecting its contact wiring to the

734/734N/734N-WiFi module Zone 2. When the on-board Form C relay activates and the user opens

the door connected to Zone 2, the zone is bypassed for the number of seconds programmed in Zone 2

Bypass Time allowing the user to enter/exit.

If Zone 2 does not restore (door closed) within the programmed bypass time, the 734 piezo pulses

during the last ten seconds. If Zone 2 restores prior to the end of the programmed time, the piezo

silences. If the zone does not restore before the programmed time, the 734/734N/734N-WiFi ends the

bypass and indicates the open or short zone condition to the panel.

Relock on Zone 2 Change: Select to turn the 734 door relay off and relock the door when Zone 2

changes state. Disabling this option leaves the relay on for the door access time when Zone 2 restores.

The default is disabled.

Zone 2 Bypass Time: Enter the number of Bypass seconds to elapse before the Bypass timer

expires. Range is from 20 to 250 seconds. If the door remains open when the timer expires a zone

open/short is sent to the panel for Zone 2. The default is 40 seconds.

Zone 3 Options

Activate Zone 3 Request to Exit: Selecting enables the Zone 3 Request to Exit (REX) option.

Disabling allows standard zone operation on Zone 3. Default setting is disabled.

Optionally connect a PIR (or other motion sensing device) or a mechanical switch to Zone 3 to provide

REX capability to the system. When Zone 3 shorts, the on-board Form C relay activates for the

programmed number of seconds. During this time, the user can open the protected door to start the

programmed Bypass entry/exit timer. After the programmed number of seconds, the relay restores

the door to its locked state.

The 734/734N/734N-WiFi module provides a bypass-only option for REX on Zone 3. When Zone 3 opens

from a normal state, only a bypass occurs: the on-board relay does not activate. This bypass-only

option uses two methods of REX. The first REX device provides the programmed Bypass entry/exit

timer. The second REX device, or manual device such as a door knob, unlocks the door.

An example of the shunt-only configuration is a door to an office that is locked 24 hours a day. Users

pass a REX motion detector positioned by the door to begin the programmed exit timer. Within the

programmed number of seconds the user must then manually activate a second device, such as a REX

device or manual door knob, to unlock the door. If the door is opened after the programmed number

of seconds, the zone goes into alarm.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 335 336

Pas de commentaire

DMP Electronics XR500 SERIES Spécifications Page 170