DMP Electronics SCS2 Manuel d'utilisateur télécharger pdf (Page 10)

JTAG-Booster for AMD ÉlanSC520

10 JTAGEL5d.doc

1.5. Error Messages

• 80386 or greater required

The JTAG-BOOSTER does not work on a 8088/8086 or a 80286 platform.

• Adapter not connected or target power fail

The JTAG-Booster wasn't found. Please check connection to parallel port and

connection to target. Check target power. Check your BIOS-Setup.

• Can't open x:\yyy\zzz\JTAGEL5.OVL

The overlay file JTAGEL5.OVL must be in the same directory as

JTAGEL5.EXE.

• Configuration file XYZ not found.

The file specified with the option /INI= wasn't found.

• Device offset out of range

The value specified with the option /OFFSET= is greater than the size of the

detected flash device.

• Disk full

Writing a output file was aborted as a result of missing disk space.

• Error creating file:

The output file could not be opened. Please check free disk space or write

protection.

• Error: Pin-Name is an output only pin

The specified pin cannot be sampled. Check the command line. Check the

initialization file.

• Error: Pin-Name is an input only pin

The specified pin cannot be activated. Check the command line. Check the

initialization file.

• Error: Pin-Name may not be read back

The specified pin can be switched to tristate, but cannot be read back. Check

the command line.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 50 51

Pas de commentaire

DMP Electronics SCS2 Manuel d'utilisateur Page 10